Printronix T6000 - Media > Handling

62
Media > Handling
Media > Handling > Print Mode
This option specifies the type of printing to be done.
Transfer
Indicates Thermal Transfer printing (ribbon installed).
Direct
Indicates Direct Thermal printing (no ribbon) and
requires special heat sensitive media.
Factory Default
Transfer
Media > Handling > Media Handling
This option specifies how the printer will handle the media (labels or tag
stock).
Tear-Off Strip
Printer prints on the media and sends it out the front
until the print buffer is empty, then positions the last
label over the tear bar for removal.
Peel-Off
Prints and peels die-cut labels from the liner without
assistance. The printer waits for you to take away the
label before printing the next one (on-demand
printing). When the optional internal rewinder is
installed with liner attached, a “Remove Label”
message will display to remind you to remove the label
before the next one can be printed. See Label Peel-Off
page 30 and Media > Handling > Peel Present table
page 64 for more information.
Not allowed if the cutter is installed. The error message
“INCOMPATIBLE WITH CUTTER” displays.
Cut
When the optional media cutter is installed, it
automatically cuts media after each label is printed or
after a specified number of labels have been printed
when a cut command from the host has been issued. It
cuts continuous roll paper, labels, or tag stock.
Only allowed when the cutter is installed. The error
message “OPTION NOT INSTALLED” displays
otherwise.
Continuous
Printer prints on the media and sends it out the front.
See Media > Handling > Continuous Mode table page
63 for more information.
Factory Default
Tear-Off Strip