System > Control > Set Lock Key
Normally, to lock or unlock the printer menu, the up/down keys are pressed at
the same time. The Set Lock Key executable menu lets you choose different
keys to lock or unlock the printer menu. You may choose almost any group of
keys as the new lock and unlock keys. You cannot use the
ENTER key or
any key combinations which are already used for other functions. One or
more keys can used simultaneously.
The
ENTER key is used to start the sequence and
the user will be asked to select a new lock key.
After following all the instructions on the front panel
(including entering the new lock key twice to confirm),
the user will be informed the process was completed. If
not successful, then the user will alerted.
The new lock combination will remain even if the
printer is powered off and back on.
System > Energy Star > Pwr Saver Time
The time interval you specify for this parameter sets the amount of idle time
before the printer goes into Power Saver mode. When you enter into Power
Saver mode, the panel backlight is dimmed, the engine shuts down, and a panel
message informs the user.
Pressing any Control Panel key or certain network access to the printer removes
the Power Saver message from the panel and the turns on the backlight (but the
engine is still shut down). Sending a print job to the printer results in a full exit of
Power Saver mode.
The options are 1, 5, 10, 15, 30, 45, 60, and 240
minutes.
When ODV is installed and enabled, about 20
seconds is required to re-initialize ODV. During the
Power Saver exiting procedure, a message will be
displayed alerting user of the required delay.
To Next Page
Loading...
