Printronix T6000 - Network > WLAN

189
Network > Ethernet > Ethernet Speed
This menu appears only if a 10/100Base-T Network Interface Card (NIC) is
installed. The Ethernet Speed menu has five different speed modes to allow
compatibility with different systems and networks.
Auto Select
Tells the 10/100Base-T NIC to perform an auto
detection scheme and configure itself to be 10 Half
Duplex, 10 Full Duplex, 100 Half Duplex, or 100 Full
Duplex.
10 Half Duplex
Tells the 10/100Base-T NIC to communicate at 10
Megabits per second using half duplex.
10 Full Duplex
Tells the 10/100Base-T NIC to communicate at 10
Megabits per second using full duplex.
100 Half Duplex
Tells the 10/100Base-T NIC to communicate at 100
Megabits per second using half duplex.
100 Full Duplex
Tells the 10/100Base-T NIC to communicate at 100
Megabits per second using full duplex.
Factory Default
Auto Select
Network > WLAN
WARNING Most of these menu items will not change until configuration of the printer is
deemed complete by the user and the printer is placed ONLINE. Upon going
online, the printer will automatically reboot and set these options.
Network > WLAN> IP Address
This item allows you to set the IP Address for the TCP/IP protocol using a
virtual keyboard. Make sure you enter the complete IP address, including the
period symbol between the segments.
Structure
Seg1.Seg2.Seg3.Seg4
Factory Default
000.000.000.000
IMPORTANT
Disable BootP, ARP or DHCP before trying to
change the IP address.
IMPORTANT
If changed, the printer reboots when it is placed
ONLINE.