Printronix T6000 - Page 150

150
Application > P-Series Setup > Alt. Set 80-9F
Determines how data in the range 80 hex – 9F hex will be treated.
Control Code
Interprets as a control code.
Printable
Prints data in this range.
Factory Default
Control Code.
Application > P-Series Setup > SFCC d command
This menu option is for backward compatibility.
Even dot plot
This option interprets the SFCC d command as even
dot plot.
Double High
This option interprets the SFCC d command as double
high. Select this option for backward compatibility.
Factory Default
Even dot plot
Application > P-Series Setup > PSeries Dbl High
This menu option allows printing compatibility between the current and older
models of Printronix printers.
Normal
This is normal Double High printing for current model
printers.
P3/4/6/9
Compat.
Where older printers printed two dot rows higher, this
option allows for compatibility by raising the print two
dot rows to match the current models dot row value
(two dot rows lower).
Factory Default
Normal
Application > P-Series Setup > FF valid at TOF
The FF valid at TOF option determines whether the printer will perform a
Form Feed when the host sends a Form Feed command, if the printer is at
the top of form.
Disable
Will not perform a form feed when the host sends a
Form Feed and the printer is at the top of form.
Enable
Performs a form feed when the host sends a Form
Feed and the printer is at the top of form.
Factory Default
Enable