Printronix T6000 - Page 289

289
Table 28. Thermal PTX_SETUP Commands
Command
Sub-Command
Parameter
Description
LENGTH
Value
Sets the page length in 1/1000”
units.
MEDIA_HANDLING
Value
Sets the type of media handling:
0 - Continuous
1 - Tear-Off Strip
2 - Tear-Off (Not Available)
3 - Peel-Off
4 - Cut
MIRROR
Value
Value of 0 turns mirroring off,
non-zero turns mirroring on.
MODE
X
Sets the print mode to Thermal
Transfer.
D
Sets the print mode to Direct
Thermal.
ODV
1
Enables the ODV unit so that ODV
begins verifying printed barcodes.
OVERSTRIKE
0
Requests the printer to back up one
form (as defined by the Form
Length) and then print out an
overstrike pattern.
This command should only be used
if the Validator > Control > Validator
Action is set to Retry Form.
WIDTH
Value
Sets the page width in 1/1000”
units.
RFID
OVERSTRIKE_REPORT
ON/OFF
Enables/disables reporting of RFID
overstrikes to the host. The default
is OFF (disabled).
STATISTICS_REPORT
ON/OFF
Enables/disables reporting of RFID
statistics to the host. The default is
OFF (disabled).
STATISTICS_CLEAR
Clears the RFID statistics.
PRINTJOB
START
jobID
Start of job marker. Results in a
“start of job” message sent back to
host through the PPM port when a
job starts printing.
END
jobID
End of job marker. Results in a “end
of job” message sent back to host
through the PPM port when the job
finishes printing.