Media > Image > Intensity Shift
This menu can be used to shift Print Intensity settings higher or lower. This
allows for higher print intensity settings for certain media while maintaining a
compatible Print Intensity value set by the host job. It can also be used to
make slight adjustments for compatibility with other emulations.
While the shift can swing -9 to +9, the actual print
intensity value is bounded with a minimum of -15
and maximum of 20.
Media > Image > Paper Feed Shift
This option represents the distance to advance (+ shift) or pull back (– shift)
the stop position of a label when Tear-Off Strip, Peel-Off, or Cut
Media
Handling option is enabled. Allows .01
inch increments.
Current Label Length (or 12.80 inches maximum)
The pull back (- shift) will be limited to the print line
position in order to prevent media from being
pulled back beyond the print head and falling off
the platen roller.
To Next Page
Loading...
