Sensors > Calibrate > Cal in Peel Mode
This option allows you to perform a calibration in Peel-Off Media Handling
mode. Calibration in Peel-Off mode does not stop and wait for you to remove
peeled labels. Therefore, be prepared to remove the labels as they are
automatically peeled.
Calibration from the panel when in peel mode is not
permitted and a warning message will display.
Auto Calibrate can be performed from the front panel in
peel mode.
This menu only visible when the peel option is
installed.
If this menu is set to Disable, then Power-Up
Action = “Auto-Cal” is ignored.
MEDIA > Handling > Label Wait Time
Media Handling is set to Tear-Off Strip or Continuous (Tear Strip Full):
Label Wait Time specifies the number of seconds after printing stops that the
printer will wait before it advances media to the tear bar position.
Media Handling is set to Peel-Off:
Label Wait Time
specifies the number of seconds the printer will wait after a
label is removed
from the peel/tear bar before starting to print the next label.
To Next Page
Loading...
