Printronix T6000 - Page 83

83
System > Control > Alarm
Determines if the printer will power-up in the ONLINE state or OFFLINE state
(Home screen).
On
An audible alarm sounds (3 beeps) when a fault
occurs, such as a paper jam.
Cont. Beep
A continuous audible alarm sounds when a fault
occurs, which can be stopped by pressing PAUSE.
Off
No audible alarm sounds.
Factory Default
On
System > Control > Media Units
Determines if distances in the MEDIA section are displayed in inches or
millimeters.
In Inches
Inches are used.
In Millimeters
Millimeters are used.
Factory Default
In Inches
System > Control > Batch Counter
Displays the number of pages remaining to be printed in a print job on the
ONLINE screen message area. This feature is supported in PGL and ZGL
only. Not available for the Postscript/PDF firmware.
Disable
Remaining pages is not displayed.
Enable
The number of remaining pages is displayed.
Factory Default
Disable
PGL Syntax
~EXECUTE;formname;[;FC][;ICNTn][;FCNTn]
ZGL Syntax
^PQ(#Pages)
WARNING
If the correct execute command is absent from the
print file, “0 Pages” will continually display on the
control panel.