Quantum Scalar i80 User Manual

Chapter 4: Configuring the Library
Configuring System Settings
Quantum Scalar i40 and Scalar i80 User’s Guide 99
4 Make another selection or press Exit.
5 Save the library configuration (see Saving the Library Configuration
on page 107).
Logical Serial Number
Addressing
The library uses the actual tape drive serial numbers by default (logical
SN addressing is disabled). Enabling logical SN addressing enables the
library to assign logical serial numbers to all tape drives in the library.
Specifically, the library assigns a logical serial number to a tape drive in a
specific location, not the serial number of the particular tape drive. If
the tape drive is then replaced by another tape drive in the same library
location, the logical serial number remains the same. From the host
application’s perspective, the replacement tape drive is the same as the
original. This setting is disabled by default.
Caution: If you change the logical serial number addressing setting,
you must power cycle the library (perform a shutdown and
press the power button) or remove and replace each tape
drive in the library in order for the change to take effect.
Operator Panel
1 Select Setup > System Settings > Logical SN Addr.
2 Press Modify.
3 Use the Up and Down buttons to select Enabled or Disabled and
press Apply.
4 Make another selection or press Exit.
5 Power cycle the library.
6 Save the library configuration (see Saving the Library Configuration
on page 107).

Quantum Scalar i80 Specifications

General

Power supply type	AC
Power requirements	100 – 240V, 50/60Hz
Power consumption (typical)	200 W
Dimensions (WxDxH)	445 x 793 x 264 mm
Media types supported	2x LTO-4
Maximum supported storage capacity	128 TB
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Media type	Tape Cartridge
Form factor	6U
Product type	Storage auto loader & library
Certification	IEC 60950, Class A / FCC part 15, ICES-003, CISPR 22, EN55022 Class A, VCCI, CNS 13438, KN22, AS/NZS CISPR 22, EN61000-3-2, EN61000-3-3 EN55024, KN24 CE, VCCI, GS, FCC, ICES, NRTL, GOST, BSMI, KCC
Product color	Black
Standard interfaces	Fiber Channel

Weight and Dimensions

Weight	23800 g