Quantum Scalar i80 User Manual

Chapter 9: Installing, Removing, and Replacing Components
Removing and Installing a Filler Plate
270 Quantum Scalar i40 and Scalar i80 User’s Guide
3 Lift the filler plate up to disengage the catch at the bottom and pull
the filler plate out of the slot.
Installing a power supply filler plate:
• On the Scalar i80, if you are using only one power supply, you
should install the power supply in the upper slot, and cover the
lower slot with a filler plate (see Figure
64 on page 270).
1 Hold the filler
plate with the thumbscrews at the top.
2 In
sert the bottom edge of the filler plate into the slot, engaging the
bottom edge of the filler plate into the bottom of the slot.
3 Pivot the filler
plate up to fit securely in the hole.
4 Tighten the thumbscrews.
Figure 64 Filler Plates Installed
Power
supply
filler
plate
Tape drive filler plate
Single
power
supply
installed
in top
slot

Quantum Scalar i80 Specifications

General

Power supply type	AC
Power requirements	100 – 240V, 50/60Hz
Power consumption (typical)	200 W
Dimensions (WxDxH)	445 x 793 x 264 mm
Media types supported	2x LTO-4
Maximum supported storage capacity	128 TB
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Media type	Tape Cartridge
Form factor	6U
Product type	Storage auto loader & library
Certification	IEC 60950, Class A / FCC part 15, ICES-003, CISPR 22, EN55022 Class A, VCCI, CNS 13438, KN22, AS/NZS CISPR 22, EN61000-3-2, EN61000-3-3 EN55024, KN24 CE, VCCI, GS, FCC, ICES, NRTL, GOST, BSMI, KCC
Product color	Black
Standard interfaces	Fiber Channel

Weight and Dimensions

Weight	23800 g