Chapter 4: Configuring the Library
Configuring System Settings
Quantum Scalar i40 and Scalar i80 User’s Guide 101
4 Make another selection or press Exit.
5 Save the library configuration (see Saving the Library Configuration
on page 107).
SNMP Enables or disables SNMP traffic to the library. This setting is enabled by
default.
Operator Panel
1 Select Setup > System Settings >SNMP.
2 Select the setting you want to modify and press Modify.
3 Use the Up and Down buttons to select Enabled or Disabled and
press Apply.
4 When finished making all changes, press Exit.
5 Save the library configuration (see Saving the Library Configuration
on page 107).
SMI-S Allows you to enable or disable SMI-S running on the library. This
setting is disabled by default.
Operator Panel
1 Select Setup > System Settings > SMI-S.
2 Press Modify.
3 Use the Up and Down buttons to select Enabled or Disabled and
press Apply.
4 Make another selection or press Exit.
5 Save the library configuration (see Saving the Library Configuration
on page 107).
To Next Page
Loading...
