Quantum Scalar i80 User Manual

Chapter 7: Encryption Key Management
Configuring Scalar Key Manager (SKM) on the Library
180 Quantum Scalar i40 and Scalar i80 User’s Guide
Figure 32 Configuring
Partition Encryption
2 If you want to change the encryption method for a partition, make
sure that no tape drives in that partition have cartridges loaded in
them. If tape drives have cartridges loaded, you cannot change the
encryption method.
3 Sele
ct an encryption method from the drop-down list for each
partition. See Tab le
6 on page 181 for a description of the
encryption methods. (For tape drives that support encryption, the
default is Al
low Application Managed.) The encryption method
applies to all encryption-capable tape drives and media in that
partition.
Note: When you change the encryption method on a partition,
the partition is taken offline. When the change completes,
the partition comes back online automatically.

Quantum Scalar i80 Specifications

General

Power supply type	AC
Power requirements	100 – 240V, 50/60Hz
Power consumption (typical)	200 W
Dimensions (WxDxH)	445 x 793 x 264 mm
Media types supported	2x LTO-4
Maximum supported storage capacity	128 TB
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Media type	Tape Cartridge
Form factor	6U
Product type	Storage auto loader & library
Certification	IEC 60950, Class A / FCC part 15, ICES-003, CISPR 22, EN55022 Class A, VCCI, CNS 13438, KN22, AS/NZS CISPR 22, EN61000-3-2, EN61000-3-3 EN55024, KN24 CE, VCCI, GS, FCC, ICES, NRTL, GOST, BSMI, KCC
Product color	Black
Standard interfaces	Fiber Channel

Weight and Dimensions

Weight	23800 g