Chapter 8: Getting Information About the Library
Viewing the Network Settings Report
214 Quantum Scalar i40 and Scalar i80 User’s Guide
Note: Do not enter more than one e-mail address in the E-mail
Address
text box on the Tools - E-mail Configuration Record
screen. If you need to send the configuration record to multiple
e-mail addresses, repeat the procedure for each e-mail address.
Before you can e-mail the configuration record, the library e-mail
account must be configured. For information on setting up the e-mail
account, see
Configuring the Library E-Mail Account on page 76.
You can only e-mail the library configuration record from the Web
client.
Web Client
1 Select Tools > E-mail Configuration Record.
2 Type an e-mail address into the E-mail Address text box.
3 Click Apply.
Viewing the Network Settings Report
The Network Settings report provides information on the following
library settings:
• Network — Host name, primary DNS, and alternate DNS
• IPv4 Settings — DHCP enabled/disabled, IP address, gateway, and
netmask
• IPv6 Settings (if IPv6 is enabled) — DHCP enabled/disabled,
stateless configuration enabled/disabled, static configuration
enabled/disabled, net prefix, gateway, and all IPv6 addresses
• SSL — SSL, port, and cipher
• SMI-S — Access (enabled/disabled) and state (enabled/disabled)
• SNMP — Enabled/disabled status for Access, V1, V2, V3, and
encryption; algorithm; and port
• SNMP-Traps — IP addresses and ports
To Next Page
Loading...
