Quantum Scalar i80 User Manual

Chapter 9: Installing, Removing, and Replacing Components
Removing and Replacing a Magazine
274 Quantum Scalar i40 and Scalar i80 User’s Guide
Figure 66 Proper Orientation
(Right-Side Magazine)
Springs
Silver rollers
3 Choose the correct bezel (left or right) from the magazine
replacement kit.
Note: If you try to install the wrong bezel, it will not fit and you
will not be able to install it.
4 Push up on the top bezel tabs and fit them over the posts on the
top of the magazine. Turn the magazine over and repeat on the
bottom (see Figure
67 on page 275).
5 Install
the two washers and two M3 screws securing the top of the
bezel to the magazine. Install them in the outer hole in each tab
(see Figure
67 on page 275).
6 T
urn the magazine over and install the two washers and two M3
screws securing the bottom of the bezel to the magazine. Install
them in the outer hole in each tab (see Figure
67).

Quantum Scalar i80 Specifications

General

Power supply type	AC
Power requirements	100 – 240V, 50/60Hz
Power consumption (typical)	200 W
Dimensions (WxDxH)	445 x 793 x 264 mm
Media types supported	2x LTO-4
Maximum supported storage capacity	128 TB
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Media type	Tape Cartridge
Form factor	6U
Product type	Storage auto loader & library
Certification	IEC 60950, Class A / FCC part 15, ICES-003, CISPR 22, EN55022 Class A, VCCI, CNS 13438, KN22, AS/NZS CISPR 22, EN61000-3-2, EN61000-3-3 EN55024, KN24 CE, VCCI, GS, FCC, ICES, NRTL, GOST, BSMI, KCC
Product color	Black
Standard interfaces	Fiber Channel

Weight and Dimensions

Weight	23800 g