Quantum Scalar i80 User Manual

Chapter 9: Installing, Removing, and Replacing Components
Removing and Replacing the Front Bezel
Quantum Scalar i40 and Scalar i80 User’s Guide 255
5 Make sure all the magazines are pulled out a few inches (or
removed) to allow you to remove and install the bezel without
damaging it.
6 Remove and set aside the two screws securing the bezel to the
bottom of the chassis (see Figure
57 on page 255).
7 Remove and
set aside the two screws securing the bezel to the top
of the chassis (see Figure
58 on page 256).
Figure 57 Bezel Screw
Locations on Bottom of Library
Bottom
bezel
screws

Quantum Scalar i80 Specifications

General

Power supply type	AC
Power requirements	100 – 240V, 50/60Hz
Power consumption (typical)	200 W
Dimensions (WxDxH)	445 x 793 x 264 mm
Media types supported	2x LTO-4
Maximum supported storage capacity	128 TB
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Media type	Tape Cartridge
Form factor	6U
Product type	Storage auto loader & library
Certification	IEC 60950, Class A / FCC part 15, ICES-003, CISPR 22, EN55022 Class A, VCCI, CNS 13438, KN22, AS/NZS CISPR 22, EN61000-3-2, EN61000-3-3 EN55024, KN24 CE, VCCI, GS, FCC, ICES, NRTL, GOST, BSMI, KCC
Product color	Black
Standard interfaces	Fiber Channel

Weight and Dimensions

Weight	23800 g