Chapter 8: Getting Information About the Library
Viewing the All Slots Report
216 Quantum Scalar i40 and Scalar i80 User’s Guide
The report contains the following information about each slot:
• Slot Type — I/E station, storage, cleaning, or tape drive slot.
• Barcode — Barcode number of the cartridge installed in the slot. No
barcode number means the slot is empty. “No_Label” means the
barcode is unreadable.
• Partition — Partition that owns the slot (I/E station slots are shared
by all partitions).
• Location — Location coordinates of the slot.
• Element Address — Element address of the slot.
• Encryption — The encryption state of the media in the slot. In order
for the library to know the encryption state, the tape must have
been placed into an encryption-capable tape drive in the library. The
encryption-capable tape drive reads and records the encryption
state of the tape, and the encryption state displays as “Encrypted”
or “Not Encrypted.” If the tape was not placed into an encryption-
capable tape drive in the library, or if the slot is empty, the
encryption state displays as “Unknown.”
• Get Count — The number of times the picker successfully removed
a tape from the slot.
• Get Retries — The number of times the picker had to perform a
recovery operation to remove a tape from the slot.
• Put Count — The number of times the picker successfully placed a
tape into the slot.
• Put Retries — The number of times the picker had to perform a
recovery operation to place a tape into the slot.
Web Client
Select Reports > All Slots.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
