ABL800 FLEX Operator's Manual 7. Replacements
Replacing waste container, fan filter, printer paper, Continued
Replacing the
printer paper
(continued)
To prepare the new roll, tear off and discard approximately the first 25 cm of paper
and cut the leading edge of the paper straight.
Release lever
Printer cover (opened)
To replace the printer paper, do the following:
Step Action
1.
Move the release lever fully back to the nearly horizontal position.
2.
Remove any leftover paper from the printer.
3.
Move the release lever forward.
4.
Make sure that the paper edge is cleanly cut.
Place the new roll into position in the printer so that the paper unreels
from underneath the roll.
The thermal side of the paper is on the outside of the roll.
5.
Aligning the leading edge of paper straight, feed it behind the drive
roller. The paper will feed through the printer automatically once the
internal sensor detects the edge of the paper.
Check that alignment is satisfactory. Realign as required.
6.
Close the printer cover, making sure the paper feeds out of the printer.
To realign the paper or to remove a paper jam, do the following:
Step Action
1.
Place the release lever in the down position.
2.
Grip the paper edges close to the printer and gently pull the paper
through the printer until alignment is satisfactory. Draw enough paper
through the printer so that all damaged paper is removed.
3.
Place the release lever in the upright position.
4.
Close the printer cover making sure the paper feeds out of the printer
through the provided slot.
7-15
To Next Page
Loading...
Need help?
General
