2. What Is what ABL800 FLEX Operator's Manual
Screen elements, Continued
The time bar is present only when the analyzer is performing a task; it follows the
progress of the current task. For example:
Top section
(continued)
The Stop button
is visible only when it is allowed to interrupt an activity
in progress.
The parameter bar lists all measured parameters available and activated on your
analyzer.
It allows you to judge the parameter status at a glance before you have to perform a
measurement.
Green parameter:
Parameter status is okay; no problem is detected on the given
measuring channel.
Yellow
parameter:
Error associated with the given parameter during last
calibration or quality control measurement. The parameter is
unreliable and will have “?” (if requested in Corrective
Actions) in front of the result.
Red parameter:
Serious error associated with the given measuring channel.
Parameter cannot be used at all and will be displayed as
“…..”; or a parameter was repressed in the Parameter Setup
program due to errors during last calibration or quality
control measurement.
NOTICE: A parameter disabled in the Parameter Setup program will be removed
from the parameter bar – see Analysis Setup Programs (Disabled versus
Deselected Parameters) in chapter 3.
Continued on next page
2-16
To Next Page
Loading...
Need help?
General
