ABL800 FLEX Operator's Manual 2. What Is what
Analyzer status, Continued
Electrodes and
Other status
The Electrodes and Other status shows the following:
•
replacement schedule for items replaced in the Hold mode
•
messages referring to replacements or user activities.
Buttons:
Replace
Highlight the item and press this button to enter the screen for
replacements of electrodes/membranes – see Replacing
membrane or electrode in chapter 7.
Log Activity
Activate “User Activities” part of the screen to make this
button visible. When the button is visible, press it to enter the
User Activity program to edit the user activities list – see
chapter 3 in this manual.
Close
Press to exit to the Ready screen.
See chapter 11: Troubleshooting.
System messages
AutoCheck
status
AutoCheck Status is available only if the AutoCheck module has been installed. It
shows the following:
•
status of the carousel and the measurements scheduled in the QC Schedule
program (see section Quality control setup in chapter 3).
•
Messages referring to AutoCheck.
Continued on next page
2-33
To Next Page
Loading...
