ABL800 FLEX Operator's Manual 3. Installation and setup
Patient reports, Continued
To make the highlighted layout a default for your analyzer press Make Default.
The default layout will be marked with (3) in the list of layouts.
Creating a
layout
(continued)
To make a test printout of the highlighted layout (patient ID items and selected
parameter groups with the parameters/units for each parameter group) press
Preview. This test print will be labeled "Preview".
To reset any user defined layout to the –R- Default layout, select the desired layout
and press –R– Default.
To delete a highlighted layout, press Delete.
Note that the Radiometer default layout cannot be deleted. The button is disabled if
only the Radiometer default layout is available.
Editing a layout
To edit a layout, do the following:
Step Action
1.
Highlight a layout in the list by touching it on the screen.
2.
Press the Edit Patient ID Layout button to edit the patient ID items –
see description on the next page.
3.
Press the Edit Patient Results Layout button to edit the parameter
groups – see description further in this section.
4.
If an automatic printout of the Acid-Base chart for this layout is
desired, activate the Print Acid-Base Chart button.
Continued on next page
3-27
To Next Page
Loading...
Need help?
General
