R&S ZNA67 - Page 647

GUI reference
R&S
®
ZNA
647User Manual 1178.6462.02 ─ 20
5.13.3.1 Controls on the Source Coherence tab
Source Coherence...
Opens the Source Coherence dialog.
If source coherence) and an imbalance sweep is acive, this button is disabled. In this
case, the relevant settings can be found in the Coherence Quick Set section.
Source Coh. On
Activates or deactivates the source coherence mode.
If True Differential Mode is active, this button is disabled.
If checked, the main tool bar shows the "Src. Coh." button, with exactly the same func-
tionality as the Source Coherence... button in the softtool tab.
Remote command:
SOURce<Ch>:CMODe[:STATe]
True Differential Mode
See "True Differential Mode" on page 312.
If Source Coherence is active, this button is disabled.
Coherence Quick Set
This section is only enabled, if Source Coherence and an imbalance sweep is active.
It allows you to specify a reduced set of coherence parameters compared to the
advanced coherence settings of the Source Coherence dialog.
Apply Wave Correction
Same function as "Wave Correction" on page 316.
Remote command:
SOURce<Ch>:CMODe:WCORrection[:STATe] on page 1411
Mode softtool