R&S ZNA67 - Page 1411

Command reference
R&S
®
ZNA
1411User Manual 1178.6462.02 ─ 20
SOURce<Ch>:CMODe:WCORrection[:STATe] <Boolean>
Same functionality as [SENSe<Ch>:]CORRection:EWAVe[:STATe].
Suffix:
<Ch>
.
Channel number
Parameters:
<Boolean> *RST: On (1)
Options: R&S ZNA-K6
Manual operation: See "Apply Wave Correction" on page 647
7.3.15.2
SOURce:FREQuency...
The SOURce:FREQuency... commands configure the sources for frequency conver-
sion measurements and control the frequency and power of the internal signal source.
SOURce<Ch>:FREQuency:CONVersion:MIXer:PMFixed................................................. 1411
SOURce<Ch>:FREQuency:CONVersion:MIXer:PMODe.................................................. 1412
SOURce<Ch>:FREQuency<PhyPt>[:CW]...................................................................... 1412
SOURce<Ch>:FREQuency<PhyPt>:FIXed..................................................................... 1412
SOURce<Ch>:FREQuency<PhyPt>:CONVersion:ARBitrary:EFRequency<Gen>............... 1413
SOURce<Ch>:FREQuency<PhyPt>:CONVersion:ARBitrary:IFRequency...........................1414
SOURce<Ch>:FREQuency:CONVersion:MIXer:PMFixed <arg0>[, <arg1>]
Assigns a fixed power to the RF, LO 1, LO 2, or to the IF signal.
Suffix:
<Ch>
.
Channel number
Parameters:
<arg0> RF | LO | LO1 | LO2 | IF
RF – mixer input signal
LO | LO1 – local oscillator signal no. 1
LO2 – local oscillator signal no. 2, for 2-stage mixer measure-
ments ([SENSe<Ch>:]FREQuency:CONVersion:MIXer:
STAGes)
IF – mixer output signal
<arg1> Fixed power
Range: The exact range depends on the analyzer model or
external generator used; refer to the data sheet.
*RST: -25 dBm (for LO)
Default unit: dBm
Example: See [SENSe<Ch>:]FREQuency:CONVersion:MIXer:
MFFixed
Manual operation: See "RF, IF and Mixer Stages" on page 365
SCPI command reference