R&S ZNA67 - Page 1409

Command reference
R&S
®
ZNA
1409User Manual 1178.6462.02 ─ 20
SOURce<Ch>:CMODe[:STATe]..................................................................................... 1409
SOURce<Ch>:CMODe:OPTimized[:STATe].................................................................... 1409
SOURce<Ch>:CMODe:PORT<Pt>[:STATe].................................................................... 1409
SOURce<Ch>:CMODe:PORT<Pt>:PHASe.....................................................................1410
SOURce<Ch>:CMODe:PORT<Pt>:PHASe:SPAN........................................................... 1410
SOURce<Ch>:CMODe:WCORrection[:STATe]................................................................ 1411
SOURce<Ch>:CMODe[:STATe] <Boolean>
Turns source coherence mode (globally) on or off. Defined coherence for individual
analyzer ports is enabled or disabled using SOURce<Ch>:CMODe:PORT<Pt>[:
STATe].
Suffix:
<Ch>
.
Channel number
Parameters:
<Boolean> *RST: Off (0)
Options: R&S ZNA-K6
Manual operation: See "Source Coh. On" on page 647
SOURce<Ch>:CMODe:OPTimized[:STATe] <Boolean>
Allows to select between optimized and raw phase control in source coherence mode
(see SOURce<Ch>:CMODe[:STATe] on page 1409).
Suffix:
<Ch>
.
Channel number
Parameters:
<Boolean> ON
Optimized phase control, applying port match corrections
and.calibration (ON, default)
OFF
Raw phase control
Options: R&S ZNA-K6
Manual operation: See "Use Port Match and Calibration" on page 648
SOURce<Ch>:CMODe:PORT<Pt>[:STATe] <Boolean>
Enables or disables defined phase coherence at physical port <Pt> for channel <Ch>.
The target phase is defined using SOURce<Ch>:CMODe:PORT<Pt>:PHASe.
Suffix:
<Ch>
.
Channel number
<Pt> Physical port number
Parameters:
<Boolean> *RST: OFF
SCPI command reference