1. Is the enveloper lever set forward at standard position?
Pull the lever forward to the standard position.
2. Is the paper set correctly?
• Adjust the side fences and end fence of the paper cassette
•
Make sure the edges of the paper are properly aligned
• Make sure the paper does not have any folds
• Make sure the paper exit tray has been lowered (closed)
3. Check inside the machine.
• Rotate the paper transport belt and check if there are any
ink leakages or paper fragments.
•
Check to see if there are any paper fragments behind the
carriage unit or maintenance unit. If there are, remove
them if possible. After removing them, perform the
cleaning procedure.
4. If none of the above work
The machine needs to be repaired:
•
Transport belt dirty or damaged. Clean transport belt.
• Replace the carriage unit.
Light density
1. Change the driver settings.
• Disable "Economy Color" in the printer driver.
•
If this occurs when performing duplex jobs (as image density
tends to be lighter with duplex prints on this model), try printing
in simplex mode.
2. If none of the above work
This is product specification.
Abnormal image
6. Troubleshooting
198
To Next Page
Loading...
Need help?
General