Action 2
• Clean transport belt.
•
Replace Registration Sensors 1, 2.
• Replace Multi Bypass Tray.
• Replace the printer.
Jam 7
(J028/J29/
J035)
Transport Jam (Tray 2: PFU)
Message
Paper Misfeeed
Press the Form Feed button.
Cause Paper longer than the paper selected in printer driver was loaded.
Details
When paper was fed from Tray 2 the paper fed but the paper failed to leave the
trailing edge sensor within the prescribed time.
Action 1
• Check the size of the paper loaded in the PFU
•
Make sure that the size of the paper selected in the printer driver matches
the size of the paper loaded in the tray.
Action 2
• Clean transport belt.
•
Replace TE sensor.
• Replace Tray 2.
Jam 8 Not Used
Jam 9 Registration Late Jam: Tray 1
Message
Paper Misfeeed
Press the Form Feed button.
Cause
• Paper feed rollers slipped, could not feed paper
• Paper caught, warped in paper feed path.
Details
After the paper fed from the tray, or when the paper was inverted for duplexing, after
the trailing edge sensor went ON, the registration sensor failed to detect within the
prescribed time.
Action 1 • Press [Form Feed] key on operation panel.
6. Troubleshooting
230
To Next Page
Loading...
Need help?
General