Action 2
• Replace inverter guide.
•
Replace TE sensor.
• Replace CTL board.
Jam 5 Transport Jam (Tray 1)
Message
Paper Misfeed
Press the Form Feed button.
Cause Paper longer than the paper selected in printer driver was loaded.
Details
After the registration sensor detected the leading edge of the paper fed from the
paper cassette, the paper failed to pass the trailing edge sensor within the prescribed
time.
Action 1 • Press [Form Feed] key on printer operation panel.
Action 2
• Replace inverter guide.
•
Replace trailing edge sensor.
• Replace CTL board.
Jam 6
(J028/J29/
J035)
Paper Feed Jam (Bypass Tray)
Message
Paper Misfeed
Remove Bypass Tray and reset the paper. If there is any paper that is jammed
remove it.
Cause
• Paper slippage
•
Paper not loaded correctly
Details
The registration sensor did not detect the leading edge of the paper fed from the
bypass tray within the prescribed time .
Action 1
• Remove bypass tray
•
Load paper correctly.
• Check inside the paper for jammed paper or paper scraps.
Error Codes
229
To Next Page
Loading...
Need help?
General