No. Message Action
01
Loading Ink... / WAIT! N
minutes
Ink being filled.
"N" indicates time required for this operation.
Do not touch any keys during the operation.
02 Processing... Print job is in progress.
03 Ready Machine is ready to print.
04 Waiting... Printer is warming up or waiting for print job data.
05 Resetting Job... A print job is being reset. Wait a few moments.
06 Setting Change... Print settings are being updated. Wait a few moments.
07
Panel Locked
Cannot use
You have pressed a locked key on the operation panel, so
release the lock.
08 Maintenance in Process…
Print head cleaning or flushing is in progress. Wait for print
head maintenance to finish.
09 Page Drying... Being dried.
10
Cleaning Feed Belt...Wait
2min
Charge leakage is being removed.
11 Shutting down... This appears while the machine shuts down.
2. Diagnostic Errors
No. Message Action
12
Hardware Problem: Ethernet
Board
Ethernet error occurred. Disconnect all connected cables,
and then cycle the machine off/on. If this message is
displayed again, call for service.
3. Warning Errors
No. Message Action
13 Low Ink
Ink cartridge is almost empty. Note the color of the ink
cartridge where ink supply is low, and then procure and
new cartridge of the same color.
Troubleshooting Guide
97
To Next Page
Loading...
Need help?
General