• The vertical encoder wheel protection cover [A] has two functions. One is a protection cover for the
vertical encoder wheel, another is a harness guide. Therefore, this cover should be removed after
the wire harnesses on it are removed.
Preparation:
•
Duplex unit (
page 48).
•
Rear cover (
page 51 "Rear Cover, Top Cover").
•
Left cover (
page 55).
•
Right cover (
page 53).
•
Bypass drawer connector (Only when the wire harnesses removing is difficult.) (
page 115)
1. Harness covers [A] [B] ( x 2 each).
Encoders
75
To Next Page
Loading...
