• Ethernet
• Wireless LAN
Permit SSL/TLS Comm.
Set the encrypted communication for SSL/TLS. If you set to [Ciphertext Only], you need to install
the SSL certificate for the printer.
Default: [Ciphertext Priority]
• Ciphertext Only
• Ciphertext Priority
• Ciphertext/Cleartext
Parallel Interface
Specify parallel interface settings. This menu appears when the IEEE 1284 interface board is installed.
Parallel Timing
Specify the parallel interface timing.
Default: [ACK outside]
• ACK inside
• ACK outside
• STB down
Parallel Comm. Speed
Specify whether or not to use DMA transfer for receiving data.
Default: [High Speed]
• High Speed
• Standard
Selection Signal Status
Specify the selection signal level of the parallel interface.
Default: [High]
• High
• Low
Input Prime
You usually do not need to change this setting.
Default: [Inactive]
• Active
• Inactive
Host Interface Menu
131
To Next Page
Loading...
