Setting Description Setting Value
Security Policy
Specify whether or not to apply
security functions to IPsec
transmissions.
If you select "Apply", you must
then select from the following
the security function(s) you
require.
• Encapsulation Mode
• IPsec Requirement Level
• Authentication Method
• PSK Text
• Phase 1 Hash Algorithm
• Phase 1 Encryption
Algorithm
• Phase 1 Diffie-Hellman
Group
• Phase 1 Validity Period
• Phase 2 Security Protocol
• Phase 2 Authentication
Algorithm
• Phase 2 Encryption
Algorithm Permissions
• Phase 2 PFS
• Phase 2 Validity Period
• Apply
• Bypass
• Discard
Encapsulation Mode
Specify the encapsulation
mode.
(auto setting)
• Transport
•
Tunnel
(Tunnel beginning address -
Tunnel ending address)
If you specify "Tunnel", you
must then specify the "Tunnel
End Point", which are the
beginning and ending IP
addresses. Set the same
address for the beginning point
as you set in "Local Address".
7. Enhanced Network Security
108
To Next Page
Loading...
