Appendix
186
11
Cannot communicate with the
server. Check the server status
and connection.
[Exit]
• If you specified to perform a Scan to Folder
(SMB) operation, check if the power of the
computer on which the Windows shared
folder exists is turned on.
• If you specified to perform a Send Scan op-
eration using a delivery server, check if the
delivery server is turned on.
• If you specified to perform a [Enter Custom
Send File] operation using the Web Status
Monitor, click [Back] on the Web browser,
enter [Login Password], and then click [Test].
If the message “Connection to the Send File
Path has failed. Confirm the settings.” is
displayed, [Send File Path] is not specified
correctly.
Sending data has failed. Scan
with the same settings and re-
send.
[Exit]
• The machine failed to send scanned data
due to a network connection problem. Af-
ter confirming that the network cable is
properly connected, try performing anoth-
er Send Scan operation using the same set-
tings. If the same message appears, there
may be network congestion. Consult your
network administrator.
Exceeded max. scan pages. To
scan remaining pages as a new
job, press [Exit] then press
the Start key.
[Exit]
• Continued scanning and reached the max-
imum scan limit (100 pages). Press [Exit].
The scanned original is sent. The specified
destination and scanning condition set-
tings remain the same even after you have
pressed [Exit]. Place the next original and
press the {
{{
{Start}
}}
} key.
Message Possible Cause and Required Action
To Next Page
Loading...
