Ricoh IS200e - Outline to Use the Network Delivery

Configuring the Scanner Settings
38
3
Outline to Use the Network Delivery
The following overview diagram shows the preparation steps to use this ma-
chine as a network delivery scanner, which function is enabled using ScanRout-
er V2/Professional. Note that the underlined
steps are essential.
Reference
There are three types of setup items: 1) items that you can configure settings
using the control panel of this machine, 2) items that you can configure set-
tings using a Web browser on a client computer, 3) items that you can config-
ure settings using both of the above. See p.41 “Initial Scanner Setup” for
details.
This manual covers only the setting procedures that you can perform using
the control panel of this machine. For details about settings this manual does
not cover, see the Web Status Monitor Help. For information about how to
view the Web Status Monitor, see p.89 “Accessing the Scanner”
Install ScanRouter V2/Professional on a com-
puter used as a network delivery server, and
make necessary settings
See the manuals for ScanRouter
V2/Professional or ScanRouter
V2/Professional Help.
Install DeskTopBinder
Lite on a client computer, and make necessary
settings
See DeskTopBinder Lite Help or the
manuals for DeskTopBinder Lite.
Configure
[
1.
System Settings
]
on this ma-
chine
See p.51 “System Settings”
Configure [General Settings] on the Web Status
Monitor
See the Web Status Monitor Help.
Configure
[
2.
SendScan Settings
]
and [4.Scan
Settings] on this machine or on the Web Status
Monitor
See p.63 “SendScan Settings”
Configure [Delivery Settings] on the Web Status
Monitor.
See the Web Status Monitor Help.
Recall the Settings on the Web Status Monitor
See p.108 “Recalling the Settings” for
details.