Order No.
35 MHz: F 8042
40 MHz: F 8043
41 MHz: F 8044
FX-30
77
2
2. POST OFFICE REGULATIONS
The R&TTE (Radio Equipment & Telecommunications Terminal
Equipment) Directive is the new European regulation which
applies to radio systems and telecommunications apparatus,
and is applicable to all such equipment which has general
conformity approval in the EC.
One section of the R&TTE Directive regulates the setting up
a
nd operation of radio systems in the European Community.
An important change compared with earlier regulations is the
abolition of approval procedures. The manufacturer or impor-
ter must submit the radio system to a conformity assessment
procedure before marketing the equipment, and is obliged to
notify the appropriate authority (register) when the process is
completed.
The CE symbol is applied to all such equipment, and indicates
that it fulfils the currently valid
European norms. An exclamation
mark is also applied to radio trans-
mitting equipment as an indication
that the approved frequencies are
not uniform throughout Europe.
This symbol is used in all the countries of the European Union.
Other nations such as Switzerland, Norway, Estonia and
Sweden have also adopted this directive. Your radio control
system is registered (i.e. approved) in all these countries, and
can legally be sold and operated in all of them.
Please note that this radio control system may only be opera-
ted on the frequencies approved for use in your country. A fre-
quency table is supplied with your system.
We are obliged to point out that the responsibility for this, and
also for operating a radio system which fulfils the requirements
of the directives, rests with you, the user. In Germany radio
control systems for models operating in the frequency bands
of 27 MHz, 35 MHz and 40 MHz do not need to be registered
or licensed, and no fee is payable, but this may not apply in
the country in which you live and operate the system. In
Germany a ‘General Licence’ to use these frequencies is gran-
ted by right, anda copy of this General Licence is supplied with
your system.
Before using the system please check whether you need to
register or license your radio control equipment in the country
where you intend to operate it.
23. CONFORMITY DECLARATION
robbe Modellsport GmbH & Co. KG hereby declares that this
product satisfies the fundamental requirements and other rele-
vant regulations contained in the following Directives:
• Regulation relating to radio equipment and telecommuni-
cations transmitting apparatus (FTEG) and Directive
1999/5/EG (R&TTE)
• Directive RL 2004/108/EG (electro-magnetic compatibility)
• Directive LVD 73-23/93/68 EWG (low voltage directive)
The original Conformity Declaration can be viewed on the
Internet under www.robbe.com: click on the logo button mar-
ked “Conform” which is included in each device description.
20. GUARANTEE
All our products, including this radio control system, are guar-
anteed for the full statutory period of 24 months. If you wish to
make a valid claim under guarantee, please contact your dea-
ler, who is responsible for the guarantee and the processing of
any guarantee claim.
During the guarantee period any material defects or faults in
operation or manufacture will be corrected by us at no cost to
you. All other claims, e.g. in the case of consequent damage,
are excluded from the guarantee.
The system must be returned to us carriage-paid; we will pay
the cost of transport back to you. We will not accept ship-
ments sent C.O.D.
We accept no liability for damage in transit or loss of your ship-
ment; we recommend that you take out suitable insurance to
cover this.
Send your equipment to the robbe Service Centre for the
country in which you live.
To process your guarantee claims the following conditions
must be fulfilled:
• The purchase receipt must be included with your ship-
ment.
• The units must have been operated in accordance with the
operating instructions.
• Recommended batteries and genuine robbe accessories
must have been used exclusively.
• Damage due to damp, tampering, reversed polarity, over-
loading and mechanical damage are not covered.
• Please be sure to include a succinct description of the pro-
blem to help us locate the fault or defect.
21. LIABILITY EXCLUSION
We at robbe Modellsport are not in a position to ensure that
you observe the operating instructions, and have no influen-
ce on the way you install, operate and maintain the radio
control system components. For this reason we are obliged
to deny all liability for loss, damage or costs which are incur-
red due to the incompetent or incorrect use and operation of
our products, or which are connected with such operation in
any way.
To Next Page
Loading...