ROBBE Futaba FX-30

To Previous Page

robbe Modellsport GmbH & Co.KG

Metzloser Strasse 36

D-36355 Grebenhain

Telefon +49 (0) 6644 / 87-0

robbe Form 40-5363 AEAI

We accept no liability for errors and technical modi-

fications.

This document may not be copied or reproduced in

whole or in part without the prior written approval of

robbe Modellsport GmbH & Co. KG

Main Page

Table of Contents2
Safety Notes3
Set Contents4
General Description5
Transmitter5
R-1410 DP PCM-1024 Receiver5
Specification6
Transmitter6
R-1410 DP PCM-1024 Receiver6
Transmitter Controls6
Lipo Transmitter Battery6
Removing / Replacing the Transmitter Battery6
RC Charger, Charging the Transmitter Battery7
Safety Notes Regarding the Lipo Battery7
Operating Times7
Inserting / Replacing the RF Module8
Stick Adjustments8
Adjusting the Stick Length8
Centring Force Adjustment8
Converting the Throttle Function8
Activating the Stick Ratchet Function8
Activating the Brake Function8
SD Card Memory Module9
Fitting the SD Card9
Removing the SD Card9
Transferring Data to a PC9
Data Back-Up9
Memory Capacity9
Notes on Handling SD Cards9
Trainer (Teacher - Pupil Mode) Mode10
Dsc Mode, Use with Flight Simulator10
Input Elements11
LCD Screen11
3-D Hot-Key / EDIT Button11
Input Button (S1)11
LED Status11
Rotary Trims11
Rotary Knobs12
Upper Rotary Trimmers12
Aerial12
Connecting the Servos13
Servo Sequence with the PCM 1024 System13
Connecting Servos - PCM 1024 and G313
Fixed-Wing Model Aircraft, Normal Elevator14
Fixed-Wing Model Aircraft, Separate (Two) Elevators15 5.4 Flying Wing Model Aircraft16
Model Helicopters17
Switching the Transmitter on and off18
Changing the Spot Frequency18
Changing the Frequency Band and Modulation20
Area Code20
Switching Frequency Band20
Selecting the Modulation20
Receiver Number (Receiver ID)20
Description of the Start Screen21
Start Screen for Fixed-Wing Model Aircraft21
Start Screen for Model Helicopters21
Menu Structure, Method of Navigation22
System Menu22
Trainer Mode22
Trainer Mode: Teacher Transmitter23
Trainer Mode: Pupil Transmitter23
Screen Settings24
Adjusting Screen Contrast24
System Time24
Total Time24
Model Time24
User's Name25
Transmitter Control Settings25
Hardware Transmitter Control Reverse25
Stick Mode25
Switches (Switch Type Assignment)25
Information26
(Language Select, Software Version Etc.) Base Menu26
Servo Monitor (Travel Indicator)27
Selecting a Model Memory27
Calling up a Model Memory27
Setting up a New Model Memory27
Erasing a Model Memory28
Renaming a Model Memory28
Copying a Model Memory28
Selecting the Model Type29
Selecting the Wing and Tail Type29
Selecting the Swashplate Type30
Selecting the Frequency and Modulation30
Function31
Assigning Transmitter Controls31
Selecting the Trim Controls31
Trim Settings31
Virtual Channels32
Switched Channels 9 + 10 and 13 + 1432
Servo Centre Offset32
Servo Reverse33
Fail-Safe Settings33
Servo Travel Settings (ATV)34
Motor Cut Function (Motor Off)35
Throttle Pre-Select (Idle 2)35
Swashplate Ring Mixer35
Swashplate Settings36
Timer / Stopwatch Settings37
Trim Display38
Data Reset39
Flight Mode Hold (CND HOLD)39
Model Menu40
Selecting Flight Modes40
Transmitter Control Travel Settings (AFR)42
Dual Rate Settings43
Programmable Mixers (PROG MIX)44
Model Menu (Fixed-Wing Model Aircraft)47
Aileron Differential47
Flap Settings48
Aileron -> Flap Mixer49
Aileron -> Brake Flap Mixer49
Aileron -> Rudder Mixer50
Airbrake -> Elevator Mixer51
Rudder -> Aileron Mixer52
Spoiler Mixer53
Flap -> Elevator Mixer54
Crow (Butterfly) Mixer54
Trim Mixer 1 and 255
Brake Flap Mixer57
Gyro Settings58
V-Tail Mixer58
Elevators with Aileron Function59
Winglet Rudder Settings59
Electric Motor Settings60
Rudder -> Elevator Mixer60
Snap Roll Function61
Model Menu (Model Helicopter)62
Collective Pitch Curve Settings62
Throttle Curve Settings64
Acceleration Function65
Auto-Rotation Settings65
Swashplate Mixer66
Throttle / Motor Mixer67
Collective Pitch -> Needle Valve Mixer68
Collective Pitch -> Tail Rotor (Revolution) Mixer68
Gyro Settings69
Speed Governor (Regulator) Settings70
Flight Mode Hold (CND HOLD)70
Transmitter Control / Switch Select Menu71
Updating the Transmitter Software72
Tips for Installing the Receiving System73
Receiver Aerial74
Switch Harness74
Servo Leads74
Servo Suppressor Filters74
Installing Servos75
Servo Travel / Servo Output Levers75
Installing Linkages75
The System in Use76
Power-On Sequence76
Electrical Noise Interference76
Electric Motors76
Electronic Ignition Systems76
Receiver Battery Capacity / Operating Times76
Guarantee77
Liability Exclusion77
Post Office Regulations77
Conformity Declaration77
Recommended Accessories78
Programming Sequence - Fixed-Wing Model Aircraft79
Programming Sequence - Model Helicopters80
Disposal82
Service Centre Addresses82

ROBBE Futaba FX-30 - Page 84

Table of Contents

Related product manuals