Rohde & Schwarz ESW Series - Page 161

Common Measurement Settings
R&S
®
ESW
161User Manual 1177.6298.02 ─ 08
Although the existing setup files are displayed in read-only mode in the editor, they can
be saved under a different name (using "File > SaveAs").
Be careful, however, to adhere to the required syntax and commands. Errors are only
detected and displayed when you try to use the new generator (see also "Displayed
Information and Errors" on page 158).
For details, see "Generator Setup Files" on page 155.
Frequency Min/ Frequency Max
For reference only: Lower and upper frequency limit for the generator.
Level Min/ Level Max
For reference only: Lower and upper power limit for the generator.
Measurement Settings
Access: "Overview" > "Input" > "External Generator" > "Measurement Configuration"
Source State............................................................................................................... 161
Source Power..............................................................................................................161
Source Offset.............................................................................................................. 162
Source Frequency Coupling........................................................................................162
(Manual) Source Frequency........................................................................................162
(Automatic) Source Frequency (Numerator/Denominator/Offset)...............................162
Result Frequency Start............................................................................................... 163
Result Frequency Stop................................................................................................163
Bargraph Frequency................................................................................................... 163
Source State
Activates or deactivates control of an external generator.
Remote command:
SOURce<si>:EXTernal<gen>[:STATe] on page 491
Source Power
The output power of the external generator. The default output power is -20 dBm. The
range is specified in the data sheet.
Remote command:
SOURce<si>:EXTernal<gen>:POWer[:LEVel] on page 490
Data Input and Output