Data Management
R&S
®
ESW
262User Manual 1177.6298.02 ─ 08
the current measurement settings are stored, not any additional data such as traces,
limit line or transducer files (see Chapter 12.3.2.1, "Stored Data Types", on page 264).
Saving instrument settings in secure user mode
Settings that are saved via Quick Save in secure user mode are stored to the SDRAM,
and are only available during the current session. As soon as the power is switched off
on the R&S ESW, the data is cleared (see Chapter 4.7, "Protecting Data Using the
Secure User Mode", on page 40).
During recall, save sets of type "Instrument" replace the settings of the entire instru-
ment. All other save sets start a new channel with the stored settings.
If a channel with the same name as the "Channel" to be restored is already active, the
name for the new channel is extended by a consecutive number:
12.3.1.1 Quick Save / Quick Recall Settings
Access: "Save"/ "Open" icon in the toolbar > "Quick Save" / "Quick Recall"
Both dialog boxes are very similar and closely related.
QuickSave 1 / ... / QuickSave 10................................................................................ 262
Storage Type (Save only)............................................................................................263
Recall.......................................................................................................................... 263
QuickSave 1 / ... / QuickSave 10
Selects one of the save sets to store the current settings in or to be recalled. At the
time of storage, the "QuickSave 1 / ... / QuickSave 10" placeholder is replaced by a
label indicating the storage date and time and the storage type.
Storing and Recalling Instrument Settings and Measurement Data
To Next Page
Loading...
