Rohde & Schwarz ESW Series - Page 469

Remote Commands in the Receiver Application
R&S
®
ESW
469User Manual 1177.6298.02 ─ 08
CALCulate<n>:PSEarch:PLISt<peak>:DELete
CALCulate<n>:PEAKsearch:PLISt<pi>:DELete
This command deletes a peak from the peak list.
Suffix:
<n>
.
irrelevant
<pi> Peak
Example: //Deletes a peak from the peak list
CALC:PEAK:PLIS4:DEL
Usage: Event
CALCulate<n>:PSEarch:PLISt<peak>:DELTa?
CALCulate<n>:PEAKsearch:PLISt<pi>:DELTa?
This command queries the distance of a peak to the nearest limit line in the peak
search.
Suffix:
<n>
.
irrelevant
<pi> Peak
Return values:
<Level> If you are using no limit line, the return value is '0'.
Example: //Query distance to limit line
CALC:PEAK:PLIS4:DELT?
//would return, e.g.
3.23
Usage: Query only
CALCulate<n>:PSEarch:PLISt<peak>:DETector?
CALCulate<n>:PEAKsearch:PLISt<pi>:DETector?
This command queries the detector with which a peak was found in the peak search.
Suffix:
<n>
.
irrelevant
<pi> Peak
Return values:
<Detector> String that contains the name of the detector.
Example: //Query detector the peak was measured with
CALC:PEAK:PLIS4:DET?
//would return, e.g.
'Average'
Usage: Query only
Measurements and Result Displays