Rohde & Schwarz ESW Series - Page 470

Remote Commands in the Receiver Application
R&S
®
ESW
470User Manual 1177.6298.02 ─ 08
CALCulate<n>:PSEarch:PLISt<peak>:FREQuency?
CALCulate<n>:PEAKsearch:PLISt<pi>:FREQuency?
This command queries the frequency of a peak found in the peak search.
Suffix:
<n>
.
irrelevant
<pi> Peak
Return values:
<Frequency>
Example: //Query frequency of a peak
CALC:PEAK:PLIS4:FREQ?
//would return, e.g.
69420000
Usage: Query only
CALCulate<n>:PSEarch:PLISt<peak>:LEVel?
CALCulate<n>:PEAKsearch:PLISt<pi>:LEVel <Level>
This command queries the level of a peak found in the peak search.
Suffix:
<n>
.
irrelevant
<pi> Peak
Parameters:
<Level> <numeric value>
The unit depends on your selection (CALCulate<n>:UNIT:
POWer).
Example: //Query level of the fourth peak
CALC:PEAK:PLIS4:LEV?
//would return, e.g.
-53.99
CALCulate<n>:PSEarch:PLISt<peak>:SIZE?
CALCulate<n>:PEAKsearch:PLISt<pi>:SIZE?
This command queries the number of peaks found in the peak search.
Suffix:
<n>
.
irrelevant
<pi> irrelevant
Return values:
<Peaks>
Measurements and Result Displays