Rohde & Schwarz ESW Series - Page 616

Remote Commands in the Receiver Application
R&S
®
ESW
616User Manual 1177.6298.02 ─ 08
Set # 1 = Number of the dataset would be "1".
Set # 2 = Number of the dataset would be "2".
Subset = Cannot be removed.
Parameters:
<Dataset> Index number of the dataset as shown in the "Test Report Con-
tent Selection" dialog box.
If the index number is greater than the number of available data-
sets, the command returns an error.
Example:
HCOP:TREP:TEST:REM 2
Deletes the second dataset from the current test report.
Manual operation: See "Adding and removing datasets" on page 299
HCOPy:TREPort:TEST:REMove:ALL
This command removes all existing datasets from the test report.
Example:
HCOP:TREP:TEST:REM:ALL
Deletes all datasets that are currently in the test report.
Usage: Event
Manual operation: See "Adding and removing datasets" on page 299
HCOPy:TREPort:TITLe <Title>
This command defines the title for the test report as shown on its title page.
Parameters:
<Title> String containing the title.
Example:
HCOP:TREP:TITL 'My first test report'
Defines a title for a test report.
Manual operation: See "Contents of the title page" on page 296
HCOPy:TREPort:TITLe:STATe <State>
This command includes or excludes the title page from the test report.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
HCOP:TREP:TITL:STAT OFF
Removes the title page from the test report.
Manual operation: See "Contents of the title page" on page 296
Data Management