Rohde & Schwarz ESW Series - Page 635

Remote Commands in the Receiver Application
R&S
®
ESW
635User Manual 1177.6298.02 ─ 08
[SENSe:]CORRection:SWITch:STORe <FileName>
This command defines the file name of a dataset that controls a switch matrix.
Parameters:
<FileName> String containing the file name and path.
The file type is xml.
Example:
CORR:SWIT:STOR 'NameOfTheFile'
Saves the dataset in the file "NameOfTheFile.xml".
Manual operation: See "Dataset name and file name" on page 325
[SENSe:]CORRection:SWITch:WAIT
<Delay>
This command defines a delay time.
The delay time is the time the R&S ESW waits until it sends the first command used in
the subsequent transducer range.
Parameters:
<Delay> <numeric value>
*RST: 100 ms
Default unit: s
Example:
CORR:SWIT:WAIT?
would return, e.g.:
0.01
Manual operation: See "Delay time" on page 326
[SENSe:]CORRection:TRANsducer:INPut<rf>:ACTive?
[SENSe:]CORRection:TRANsducer:ACTive?
This command queries the currently active transducer factor.
Parameters:
<TransducerFactor> String containing the name of the transducer factor.
If no transducer factor is active, the string is empty.
Example:
CORR:TRAN:ACT?
Queries the active transducer factor.
Usage: Query only
[SENSe:]CORRection:TRANsducer:ADJust:RLEVel[:STATe] <State>
This command turns an automatic adjustment of the reference level to the transducer
on and off.
Before you can use the command, you have to select and turn on a transducer.
General Instrument Setup