Measurements and Result Displays
R&S
®
ESW
99User Manual 1177.6298.02 ─ 08
Min peak detector levels
Note that for the min peak detector, the peak level is not the highest level, but the low-
est level.
1 2
Figure 9-2: Screen layout of the bargraph result display with the max hold information
1 = maximum levels
2 = frequency on which the maximum level has been measured; note that the minimum and RMS peaks
have been measured at frequency different to the current receiver frequency
The "Bargraph" dialog box contains a preview of the measurement and all settings that
you can apply to the bargraph.
Bargraph configuration
When you are performing a scan that is not based on a scan table, the R&S ESW
applies the bargraph settings (detector, measurement time etc.) to the scan.
The remote commands required to configure the bargraph are described in Chap-
ter 15.5.4, "Bargraph Configuration", on page 450.
Functions to configure the bargraph described elsewhere:
●
"Receiver Frequency" on page 178
●
"Detector" on page 133
Bargraph Configuration
To Next Page
Loading...
