Rohde & Schwarz SGS100A - Page 264

Remote Control Commands
R&S
®
SGS100A
262User Manual 1173.9105.02 ─ 12
Setting values: A decimal value in the range 0 to 32767 (=2
15
-1)
:STATus:OPERation:CONDition?.....................................................................................262
:STATus:OPERation:ENABle...........................................................................................262
:STATus:OPERation[:EVENt]...........................................................................................262
:STATus:OPERation:NTRansition.................................................................................... 263
:STATus:OPERation:PTRansition.....................................................................................263
:STATus:PRESet............................................................................................................263
:STATus:QUEStionable:CONDition.................................................................................. 263
:STATus:QUEStionable:ENABle.......................................................................................264
:STATus:QUEStionable[:EVENt]...................................................................................... 264
:STATus:QUEStionable:NTRansition................................................................................264
:STATus:QUEStionable:PTRansition................................................................................ 264
:STATus:QUEue[:NEXT]?................................................................................................265
:STATus:OPERation:CONDition?
Quieries the content of the CONDition part of the STATus:OPERation register.
This part contains information on the action currently being performed in the instru-
ment. The content is not deleted after being read out because it indicates the current
hardware status.
Return values:
<Condition> string
Example:
:STATus:OPERation:CONDition?
Usage: Query only
:STATus:OPERation:ENABle <Enable>
Sets the bits of the ENABle part of the STATus:OPERation register. This setting deter-
mines which events of the Status-Event part are forwarded to the sum bit in the status
byte. These events can be used for a service request.
Parameters:
<Enable> string
Example:
:STAT:OPER:ENAB 32767
all events are forwarded to the sum bit of the status byte.
:STATus:OPERation[:EVENt] <Event>
Queries the content of the EVENt part of the STATus:OPERation register. This part
contains information on the actions performed in the instrument since the last readout.
The content of the EVENt part is deleted after being read out.
Parameters:
<Event> string
Example:
:STAT:OPER:EVEN?
queries the STATus:OPERation:EVENt register.
STATus Subsystem