Roland TrueVIS VG2-540 - Page 115

NORMAL CL.
AB
7. Press [▲] to display the screen shown below.
8. Press [ENTER].
Prinng of the test paern starts.
9. Check to make sure the dot drop-out or dot displacement has been corrected.
If the problem persists, try performing normal cleaning again. If the printer has been used for a long period,
dot drop-outs may not be xed even aer performing normal cleaning two or three mes. If this is the case,
clean using a dierent method.
RELATED LINKS
・ P. 231 "When Normal Cleaning Is Not Eecve"
Preparations before Cutting with Crop Marks
114 4. How to Cut with Crop Marks