Roland TrueVIS VG2-540 - Cutting with Crop Marks; Step 1: Batch Settings for Cutting with Crop Marks

Step 1: Batch Sengs for Cung with Crop Marks
To ensure the opmal output according to the media size and type, you can congure various sengs on this ma-
chine. However, it is hard work to congure these sengs one at a me. You can use the "MEDIA SETTING" menu
to congure the absolute minimum of necessary items as a batch. You can save the seng details as a preset.
Note that you can set all the items set here individually as well.
1. Start the "MEDIA SETTING" menu.
Procedure
1. Load the media.
Check that the media is not sagging. If any sagging exists, sengs such as the correcon values will not
funcon eecvely.
2. Press [MENU].
3. Press [ENTER].
MENU
MEDIA SETTING
If you want to cancel the batch sengs before they are completed, see the following page.
RELATED LINKS
・ P. 73 "Canceling Batch Sengs before They Are Completed"
Cutting with Crop Marks
4. How to Cut with Crop Marks 117