Roland TrueVIS VG2-540 - Switching off the Print Heater and Dryer Together

Switching O the Print Heater and Dryer Together
This seng is useful when you want to switch o the media heang system collecvely, such as when performing
only cung. Seng the heater sengs "POWER" to "OFF" will cause temperature sengs of the print heater and
dryer to become impossible.
Procedure
1. Press [FUNCTION].
2. Press [▼] several mes to display the screen shown below.
FUNCTION
HEATER CONFIG
3. Press [▶] to display the screen shown below.
HEATER CONFIG
POWER ON
4. Press [▶].
5. Press [▲] or [▼] to select "OFF."
HEATER CONFIG
ON OFF
6. Press [ENTER] to conrm your entry.
The sengs for the print heater and dryer are turned o.
7. Press [FUNCTION] to go back to the original screen.
MEMO
• Default seng: "ON"
IMPORTANT
When this is set to "OFF", the heater will not turn on even if the heater temperature is set in the included soware RIP.
Adjusting the Ink-drying Method
160 1. Optimizing the Output Quality