Is an error message displayed?
If an error message is displayed because the media has jammed, immediately correct the problem. Doing so may
damage the print heads.
RELATED LINKS
・ P. 302 "MOTOR ERROR: TURN POWER OFF"
Is the media warped or wrinkled?
Many factors can cause warping or wrinkling. Refer to the following and correct the problem.
RELATED LINKS
・ P. 284 " Media Wrinkles or Shrinks"
Is the height of the print heads too low?
Try raising the print heads higher. First, try seng the height to "MIDDLE," and if the media is sll jammed, change
it to "HIGH." Media may inevitably warp or wrinkle slightly, so adjust the height of the print heads to take this into
account.
RELATED LINKS
・ P. 144 "Adjusng Print Head Height to Match Media Thickness"
Are the grit rollers dirty?
Check to make sure the grit rollers are free of buildup of foreign material such as media scraps.
RELATED LINKS
・ P. 223 "Cleaning the Machine"
Are the media clamps aached?
When you are performing prinng, be sure to aach the media clamps.
Is the media loaded and set up straight and securely?
Feeding is not smooth when the media is not straight or is tensioned unevenly on the le and right. Reload the
media.
RELATED LINKS
・ P. 30 "Setup of Roll Media"
・ P. 40 "Setup of Sheet Media"
Is some other object coming into contact with the media?
Make sure the media does not touch anything else. This may aect output, even when the feed appears to be
smooth.
RELATED LINKS
・ P. 30 "Setup of Roll Media"
A Media Jam Occurs!
3. Media Feed Problems 287
To Next Page
Loading...
