Roland TrueVIS VG2-540 - Prioritizing the Cutting Settings of this Machine over the Software RIP Settings

Priorizing the Cung Sengs of This Machine over the Soware RIP Sengs
Procedure
1. Press [MENU].
2. Press [▲] several mes to display the screen shown below.
MENU
CUTTING MENU
3. Press [▶] once, and then press [▼] several mes to display the screen shown below.
CUTTING MENU
CUTTING PRIOR
4. Press [▶] to display the screen shown below.
CUTTING PRIOR
COMMAND COMMAND
5. Press [▲] or [▼] to select "MENU".
Priorize the cung condions set on the machine over the soware RIP sengs.
If this is set to "COMMAND", priority is given to the soware RIP sengs.
CUTTING PRIOR
COMMAND MENU
6. Press [ENTER] to conrm your entry.
7. Press [MENU] to go back to the original screen.
MEMO
• Default seng: "COMMAND"
Accurately Adjusting the Cutting Settings
168 1. Optimizing the Output Quality