Roland TrueVIS VG2-540 - Setting the Activation Interval for Sleep Mode (Power-Saving Feature)

Seng the Acvaon Interval for Sleep Mode (Power-saving Feature)
This seng is used to set how long it should take unl the machine goes into sleep mode (the state in which pow-
er-saving feature is working) when recepon of output data or non-operang state connues.
Procedure
1. Press [MENU].
2. Press [▼] several mes to display the screen shown below.
MENU
SUB MENU
3. Press [▶] once, and then press [▼] several mes to display the screen shown below.
SUB MENU
SLEEP
4. Press [▶] twice to display the screen shown below.
INTERVAL
30min 30min
5. Press [▲] or [▼] to set the me.
INTERVAL
30min 15min
6. Press [ENTER] to conrm your entry.
7. Press [MENU] to go back to the original screen.
MEMO
• Default seng: 30 min
Managing the Operations Appropriately and Efficiently
3. Optimizing Operation Management 211