Roland TrueVIS VG2-540 - Wrong Cartridge; Canceled for Pump Protection; Avoiding Dry-Up Turn Power off; Set Head Height to

Raise the loading lever and move the pinch roller to the correct locaon.
RELATED LINKS
・ P. 30 "Setup of Roll Media"
・ P. 40 "Setup of Sheet Media"
WRONG CARTRIDGE
Has an ink pouch that cannot be used been installed?
Remove the pouch tray to clear the error. Use an ink pouch of the specied type.
CANCELED FOR PUMP PROTECTION
The printer made an emergency stop because a state in which ink was not present connued for 10 minutes or
longer while cleaning (normal, medium, powerful, damper, super, or automac cleaning while sub power was
switched o) was in progress or during the rst ink lling procedure for the machine.
Operaon cannot be connued. Turn o the sub power. Aer turning the power o, contact the your authorized
Roland DG Corporaon dealer.
AVOIDING DRY-UP TURN POWER OFF
The print heads were forced to the home posion to prevent them from drying out.
Operaon cannot be connued. Switch the sub power o, and then back on.
SET HEAD HEIGHT TO ****
Is the height of the print heads lower than the height specied in the soware RIP?
This warning indicates that the height of the print heads is too low for the media thickness specied in the so-
ware RIP. The print heads move to a locaon where you can operate the height-adjustment lever. Adjust to the
displayed height, and then press [ENTER].
RELATED LINKS
・ P. 144 "Adjusng Print Head Height to Match Media Thickness"
MOTOR ERROR: TURN POWER OFF
1. A motor error occurred.
2. The media has jammed.
3. Has the media been pulled with excessive force?
1. Operaon cannot be connued. Turn o the sub power. Next, eliminate the cause of the error, then immedi-
ately switch on the sub power. If the machine is allowed to stand with the error uncorrected, the print heads
may dry out and become damaged. This error may be caused by such factors as a mistake in loading the me-
dia, a media jam, or an operaon that pulls the media with excessive force.
2. Carefully remove the jammed media. The print heads may also be damaged. Perform head cleaning, and then
perform a prinng test and check the results.
3. Excessive tension was applied to the media, and addional acon is necessary to recover from this state. First,
raise the loading lever and adjust the media to create a small amount of slack, and then switch on the sub
power.
SERVICE CALL ****
An unrecoverable error occurred or part replacement that must be performed by a service technician is re-
quired.
Error Messages
302 5. Messages on the Operation Panel