Roland TrueVIS VG2-540 - Setting the Dryer Temperature

Seng the Dryer Temperature
Seng the temperature of the dryer appropriately makes the ink dry fast.
• With the default sengs, simply switching on the power does not make the dryer warm up to the set temper-
ature. The temperature rises to the set temperature when the media is loaded correctly and [SETUP] lights.
• Depending on the usage environment, the temperature of the print heater may become higher than the set
temperature, but this does not represent a problem.
• Temperature sengs are not possible when heater sengs "POWER" is "OFF".
Procedure
1. Press [FUNCTION].
2. Press [▼] several mes to display the screen shown below.
FUNCTION
HEATER CONFIG
3. Press [▶] once, and then press [▼] twice to display the screen shown below.
HEATER CONFIG
DRYER 40゜C
4. Press [▶] to display the screen shown below.
DRYER
50゜C 50゜C
5. Press [▲] or [▼] to select the temperature.
When ink drying is poor, raise the temperature. Note, however, that a temperature that is too high may de-
grade the media or cause it to wrinkle.
You can also set the temperature to "OFF". When set to "OFF", the dryer does not operate at all.
6. Press [ENTER] to conrm your entry.
7. Press [FUNCTION] to go back to the original screen.
MEMO
• Default seng: 45°C (113°F)
• You can also make this seng in the soware RIP. When you have made the seng in the soware RIP, the soware RIP's
seng is used.
Adjusting the Ink-drying Method
154 1. Optimizing the Output Quality